Succubus - Mineral Hunter 32&75mm

Succubus - Mineral Hunter 32&75mm

Item description:
Ready to print pre-supported models.

The files are provided in two forms:
- Pre-supported STL files
- Unsupported STL files

Miniature for 3d printing, suitable for resin, 32&75mm pre-supported, great for players, painters and collectors in the RPG universe.

1) Resin Settings
Resin Type: Water Washable Resin
Resin Density: 1.100g/ml
2) Print Parameters
Layer Height: 0.050mm
Bottom Layer Count: 5
Exposure Time: 2.200s
Bottom Exposure Time: 30.000s
Transition Layer Count: 5
Transition Type: Linear
Time Difference, likely for gradient transition: 4.633s
Rest Time Before Lift: 0.000s
Rest Time After Lift (Release): 0.000s
Rest Time After Retract: 1.000s
3) Production Instructions
Preparation:
Model Preparation: Ensure your 3D model is correctly oriented and has the necessary supports for successful printing.
Resin Filling: Pour a sufficient amount of Water Washable Resin into the vat.
Calibration: Check and, if necessary, perform platform calibration (leveling).
Temperature: Ensure the room temperature is in accordance with the resin manufacturer's recommendations (usually 20−30°C).

Printing Process:
File Loading: Load the slice file (usually *.photon, *.ctb, etc.) onto the printer.
Start Printing: Start the printing process. The printer will begin with 5 bottom layers with a long exposure time (30.000s) for reliable adhesion.
Transition: After the bottom layers, the printer will perform 5 transition layers with a linear change in exposure time down to 2.200s.
Main Print: After the transition, printing will continue with a layer height of 0.050mm and an exposure time of 2.200s.
Wait Time: At the end of each exposure cycle, there is a 1.000s delay after platform lowering to allow the resin to stabilize.

Post-Processing:
Model Removal: Carefully remove the finished model from the platform.
Cleaning: Since Water Washable Resin is used, rinse the model in clean water (isopropyl alcohol is not required). Use a soft brush to remove resin residue.
Post-Curing: Place the cleaned and dried model in a post-curing chamber or under a UV lamp for full curing.
Important: Ensure the model is completely dry before post-curing.
Support Removal: Remove all support structures.