Caixa de cartas MTG Commander FmP - Empilhável

FmP's new Commander Box opens ready to play. An easy 5 part print that fits on any 220x220 bed, has all the features. A Commander Displaying "Sleeve Key" to lock the whole box, Drawer for Dice and counters, and a "Lid" that doubles as a tray during play. Also, it's Stackable!

How It Works:

This box is locked in tight with a Protective "Sleeve Key" that holds your Commander in a top loader, in a sleeve, in another sleeve. Put the "Sleeve Key" out to slide the Top Body off, flip it over and you're ready to play. You can even hold the "Sleeve-Key" with the "Top Body" in play position. It comes complete with a magnetic drawer using 3mm x 6mm Neodymium magnets to hold it snug in place with the track that the "Drawer Lid" it slides into.

Orientation:

All STLs are set in the correct Orientation. All Flat Sides Down, besides the Sleeve, which is printed standing up.

*0.2mm Layer Height

*10-20% infill is fine

*3-4 walls min.

*Only supports for the "Base Body" stacking track at the bottom and for the "Sleeve". Organic supports is suggested.

Assembly:

Magnets - 3mm x 6mm Neodymium Magnets are inserted in the slots of the drawer FIRST. Make sure the polarities face the same direction. Place magnets on the other side of the current magnets, they should stick to it through the plastic. Next, slide the drawer into the "Top Body" slot for the drawer all the way until the new magnets are seated in their holes.

Now remove the drawer, place the lid (flat side up) on the drawer, reinsert the drawer in the "Top Body" and then turn the Top over and slide it into place on the "Base Body'. Slide the "Sleeve Key" from the top to the bottom through the front track. Now you're done.