Torre de dados com armadilha de palmas (Borderlands)

!!! Multiple pieces !!!
Dont need multi color , but need patience ;)

Need:
- Magnet 2x8mm (x8) optional
- screw M3 min. 6mm Max. 8mm (x2)
M3 min. 10mm max. 20mm (x4)
M3 min. 40mm max. 45mm (x2)
- nuts M3 (x2)
- super glue ( I put mind in pictures )

Quantity:
HEAD BLOCKER (X4)
EPAULE (X2)
bras (x2)
roue goujon (x2)
Center cap (x2)
*if the part is not here you will need one

Choice:

Laser V2. need to use translucent/transparent filament on front part
Base. you have 3 choice but the best is V2

explanation:

BODY.
you need to put manually the color change,(head on bed, I put color change on 51.6mm to 86mm But dont care about that)

HEAD. (need EPAULE part)

4 HEAD BLOCKER need to be glued below
4 magnets need to be glued (be careful to put them all on the same side)
screw EPAULE on the HEAD ( M3 10to20mm )
Manually color change for antenna

BRAS.
probably the hardest parts to print
Make sure to screw it to the BODY before doing next step with BODY(CORE) (Screw M3 6to8mm)

BODY(CORE).
4magnets need to be glued
make sure to do the previous step with BRAS before gluing BODY(CORE) inside the BODY
BODY(CORE) have way for the dice fall on the correct side, you can test with a dice to make sure the correct direction

OEIL.
Test all the parts before putting glue
Be careful to put it on good position
OEIL inside OEIL SUPPORT inside OEIL CORE inside BODY(CORE) (all be gued)

LASER.
Personaly I use V2 , Multi color for BACK pieces, Translucent blue for FRONT one . I added small drops of glue to create the broken effect
Glue it on the BODY

WARNING.
Very basic parts just glue it

ROUE. (need CENTER CAP and GOUJON)
Put your 2 nuts on you screw (M3 40to45mm) to put them into the hole upside (careful twice hole for GOUJON twice for nuts).
glue CENTER CAP with flat spot upside on ROUE
Personaly I did not glue the studs to give a lively look

BASE.
Screw BASE on ROUE (M3 40to45mm)

Enjoy !!