Caixa de litofane rotativa e empilhável

Your are looking for a rotatable and stackable Lithophane Box? Here it is.

You can stack it any height you like. It only depends on the length of your LED stripe.

Each box needs 1.7 meters. The box shown uses a 5 meter LED
stripe.

LED stripe used:
https://amzn.eu/d/hJkhZqm
Length: 5 m
Width 10 mm
(best for a lot of color effects when using the app)

If you use any other LED stripe than the above one or different type then please use "Base for IR stripe"

Box size: 206 x 206 x 122.5 mm

Base size: 206 x 206 x 40 mm

https://youtu.be/7kVZVh6qToA

Printer: ELEGOO Neptune 4
Filament: PLA+
Colors:
All parts: Black
Lithophanes: ELEGOO White (has a little warmer color than other white filament)
Supports: No

Instructions:
Print base first and insert the whole LED stripe into base.
Print LED holder and screw it to the base.
Wrap LEDs around the holder.
Print "Top and Bottom" twice.
Print 4 colums and press them to the bottom part (no glue needed)
Now print 4 Lithophanes and put between the columns
Take Top part and press it on all 4 columns.
Print a spacer ring and put it in the deepening of the base,
Take the box and put it centered on top of the ring.
Print top knob and screw it to the LED holder
If box cannot be rotatet for any reason you need one or more spacers on top of the LED Holder.
Even if you don´t have to glue anything I would suggest to glue the holder to the base (Prevents from ripping off the LEDs if you open the top knob.)
If you want to stack boxes you always need a spacer ring for each box whitch sits between two boxes
I have made the screws very loose so that you should not have any problems with a uncalibrated 3D printer.
Ones assembled completely it can´t fall apart however you raise it up :)