MultiStand

This stand is designed to raise the back of your laptop by 20 mm and includes an integrated phone holder on the right side. The product supports a width range of 240 mm to 425 mm. It has been tested with a 17-inch Monster laptop for compatibility.

Printing Parameters:

Infill: 10%
Material: PLA (ensures safe and efficient performance)
For fasteners, M16 trapezoidal nuts and screws were used, providing excellent clamping efficiency. Apart from the nut, no support structures were required for the other parts during printing.

Part-specific Notes:

Mutlistand_Part06: I split this part into two using Orca Slicer before printing.
Mutlistand_Part01: Printed as a single piece, but you can choose to print it in two pieces if preferred.
The keys can be fixed into the shaft key slots using fast-drying adhesive after placement.
Additionally, please refer to the included images for detailed assembly and usage instructions.

3D Printing Settings:
Infill: 80%
Material: PLA (ensures safe and efficient performance)
Layer Height: 0.2 mm
Nozzle Size: 0.4 mm
Print Speed:
Initial Layer Speed: 50 mm/s
Outer Wall Speed: 150 mm/s
Inner Wall Speed: 300 mm/s
Infill Speed: 400 mm/s
Bed Temperature: 60°C
Nozzle Temperature: 200-210°C
For fasteners, M16 trapezoidal nuts and screws were used, providing excellent clamping efficiency. Apart from the nut, no support structures were required for the other parts during printing.