Sprint Car that rolls!

I looked everywhere for a decent sprint car file that I could print and paint. Couldn't find one that wasn't designed for a resin printer. So I made my own. There is some gluing involved but it was the only way to limit the amount of supports needed.

Suggestions:
Print the Body separate so you can use TREE supports to support the thin roll cage rails on the top.
I have had issues printing the axels so I also print those separate with a brim and standard supports.
I then print the wheels, front wing and top wing all together with normal supports where needed, which is basically just under the front wing there is a small gap between the bed and the part.

Once all the parts are printed all you have to do is super glue the front wing on and the top wing on. You can set the wings where ever you'd like to acquire the look you want. Maybe you want your top wing all the way forward or all the way to the back of the roll cage. Same with the front wing, you can place it up further on the hood or closer to the ground. You may need to do some sanding to get the axels into the wheels but I wanted a tight fit. Have fun with it!

Printed on a Bambu P1S with standard PLA settings and I left my speed the factory speed settings.

Brim and standard supports on the front wing, Axels, and I used brim on the top wing as well just because.

I always set my bed to 70 but you know your printer better than I do.

FDM PRINTING