Holder

pls. try this holder...

Printer Setting Instructions
• Set Up the Slicer
• Slicing Software: Use software like Cura, PrusaSlicer, or Simplify3D.
• Layer Height: Lower values (e.g., 0.1 mm) for fine details; higher values (e.g., 0.3 mm) for faster prints.
• Infill Density: Adjust based on strength requirements (10-20% for most projects, higher for strength).
• Prepare the Printer
• Level the Bed: Ensure the print bed is level for proper adhesion.
• Clean the Bed: Use isopropyl alcohol to remove dust or grease.
• Check Filament: Ensure the filament is properly loaded and free from tangles.
• Monitor the Print
• First Layer: Watch the first layer to ensure proper adhesion and no warping.
• Temperature: Maintain the correct nozzle and bed temperature for the material.
• Watch for Issues: Pause if you notice under-extrusion, stringing, or layer shifting.
• Post-Processing
• Sanding: Sand the print for a smoother finish.
• Painting: Apply primer before painting for better adhesion.
• Resin Prints: Wash with isopropyl alcohol and cure under UV light.

K1 Printer, approx. 25 min print time FOR BOTH PRINT , 0.2mm layer height, 10% infill, PLA material.
, print in place.
Try this amazing Holder