TT01 - Mi9 Nano Shock Mod

This bracket allows you to use the beautifully designed Mi9 shocks on a Tamiya TT-01.
Thanks to Joel at rccartips who originally thought of putting these shocks on a TT-01.
Each bracket bolts to the TT-01 diff case using two 10mm long M5 bolts. Depending on the top arms you are using, you may need to also add washers to prevent binding.
You also need 4x m3 bolts, approx 15mm. A bit longer or shorter is ok.

The shocks are further in towards the body compared to the Mi9, so you may want to use a stiffer spring than you would run on an Mi9 to compensate.

I used:
7 walls
4 top, 4 bottom layers
Polymaker ASA
If you don't have a printer with a heated chamber then it may be better to use PLA to ensure good layer adhesion.