Sand Scorcher Component Box

I created a rainproof component box to house the battery and the vital electronics for my buggy. My intention was to incorporate the standard hard-shell LiPo battery with the (lighter) electronics mounted at the sides. The intention was to keep the battery and servo in line with the chassis so as to keep the CG close to the center, thus, minimizing roll during turns.

NOTE: This Battery Unit is NOT
intended for the Sand Scorcher
or Rough Rider chassis using the
Torsion Bar Suspension System.
I removed the torsion bars of my
rear suspension so that I can use
shocks that can be adjusted to
accommodate the drive terrain

The top hump accommodates the battery plug so as to allow the top cover to close firmly. My intention for creating a removable dome was so that I can replace it, in the future, with a custom dome that will be able to properly secure the electronics for the lights. I suggest using contact cement (or something else you prefer to use) to keep the dome secure. Likewise, bond the rubber foam to the upper lid to eliminate shifting.

Hope you like it. Feel free to modify it to meet your needs.

Basic prerequisites for printing each object:

Sand Scorcher Main Battery Unit.stl
Infill Density: 100%
Supports: Yes

Sand Scorcher Battery Cover.stl
Infill Density: 100%
Supports: No

Sand Scorcher Battery Cover Dome.stl
Infill Density: 20%
Supports: Yes

Sand Scorcher Battery Cover Foam Cutout Template.stl
Use this template to cut a foam sheet that will snugly fit into the inside of the cover.
Infill Density: 20%
Supports: No

Lower Plugs.stl
Infill Density: 20%
Supports: No