Nintendo Switch 日本語クラウドドック - クラシック版と有機EL版

Print-in-place
No Support Needed
Both Switch OLED AND Switch CLASSIC versions are included.

Do you want a fantastic way to customize your Switch Dock?
Here's the Nintendo Switch Japanese Cloud Dock Decor!
Super easy to print in any color to go along with your TV setup!

The model was carefully designed not to obstruct the AirFlow of the Switch or the cables at the back. Note that the USB ports will be covered, though.
The two parts snap and stay put together nicely!

⭐⭐⭐⭐⭐
IMPORTANT NOTE:
If you want to sell 3D prints based on my designs legally, please become a supporter on the Thangs Membership:
🔵Thangs - Membership

All my Designs are covered by a Creative Commons Non-Commercial License on Cults 3D. The sale of prints using my designs is the sole right of myself, the designer, and my active supporters to do so. Please understand every design is many days of work and multiple prototype prints to ensure quality.

Happy printing!

To get the best out of the STL file, please follow these guidelines:
• No support is needed for any parts. Everything is Print-in-Place.
• Layer Height 0.2mm
• Nozzle 0.4mm
• Recommended infill 15%.
• Recommended Infill Pattern: Gyroid or Cubic

• Prepare and clean your bed for excellent adhesion.
• Do not print over 50 mm/s. A lower speed like 40 or even 30 mm/s will always produce better results.
• Make sure your bed is correctly leveled. Then check again :D
• Try to hide the seam and place it where nobody will pay attention.
• Make sure your printing and bed temperatures are adequate for the filament you are about to use.