The ball trapped in the cube.

Cat toy or other ...

Printing of this object is done without generating supports. They were included during object creation.

To create this object, you need to make 3 different prints, inserting the 1st print into the 2nd and the 2nd into the 3rd. Take the opportunity to change the colors of the filaments used. It's a little challenge!

1st printing of 2 rings (here, the blue ones)

2nd print the ball and its mesh. You'll need to stop printing and insert the 2 previously printed rings before the stitches close. (I chose 3 different colors - yellow to start, green for the small amounts and before going to organ I inserted the 'blue' rings previously printed)

NOTE: as the ball was empty, I slipped a small marble into it. This adds a little noise. An extra attraction for the cat.

3rd print the cube, which I wanted to be white and black, in the same way, start the print and before the cube closes, insert the ball, letting the mesh pass through one of the holes in the cube.

Voila, I've had a lot of fun printing this object, now it's the cat's turn!

Good printing.

Dimensions

50 mm cubes, mesh length 31 mm, height 17 mm.

Total length after assembly 170 mm

All PLA in 0.3mm.