DIY Buttonbox for steering wheel

It was time to make a second buttonbox, but now with a bigger screen.
The buttonbox is made fit to use a 3.2 inch Nextion.

You can choose from different paddle shifters. Depends on your taste and the distance you have to travel with your hands.

If i am correct the buttonbox will fit for the most omp, momo and sparco wheels.
I included some canvas photos for it.

Also you will get a sticker set. If you want it in different colors, you can message me and can make it.

Materials you need:
1x Nextion - NX4024TO32
2x micro lever switch
1x Leo bodnar BU0836A-NC(low profile)
1x Leo bodnar BU0836A break out
1x Arduino Pro micro (for Nextion)
1x small usb hub.
Options:
https://www.tindie.com/products/tinkerboy/tinkerboy-4-port-usb-hub-breakout-board/

https://www.tindie.com/products/mux/microhub-the-smallest-usb-hub-with-connectors/

https://www.tindie.com/products/mux/4-port-nanohub-tiny-usb-hub-for-hacking-projects/

https://www.yoctopuce.com/EN/products/extensions-and-networking/micro-usb-hub-v2"

8x 15 x 3 N52 Magnet
2x CTS 288 Encoders
8x Knitter buttons:
http://www.leobodnar.com/shop/index.php?main_page=product_info&cPath=98_74&products_id=189
or
https://bit.ly/2MVw2fj
1x GX12-4pin connector

Shifters:
4x M4 x 10
4x M3 x 10
4x M3 Lock Nut
4x M4 x 16
4x M2 x 10/12
4x M2 Lock Nut
8x 15 x 3 N52 Magnet
4x M4 Lock Nut

Front:
6x M5 x 70
4x M3 x 12 (countersunk)

If you dont use the spacer:
6x M5 x 40

Box:
4x M3 x 10 for Nextion
4x M2,5 x 10 (for bodnar board)

Encoder:
2x M3 x 3 adjusting screw

For personal use only - non commercial - not for resale
You cannot sell the digital model, a derivative or adaptation of the model, nor can you sell prints of the model.

If you have any question, if you want to talk about the project, if you want to speak to other builders or if you are interested in new projects, join my Discord: https://discord.gg/mN3FwkN9WB

70% infill for all will be good.