Blessed Sanctuary

These are proxy models for an existing game system and are not intended for use as permanent replacements for their legitimate game model counterparts.

A safe place of worship for your Space Nuns!

Print as follows, making sure to place each piece flat against the build surface. I made each of these pieces so that they can print easily with no supports by making one side flat without detail. The balcony and crenellations should also print without supports just fine as well.

FIRST FLOOR:
-Window Panel 1st Floor Face
-Long Wall 1st Floor
-Long Wall 1st Floor (Mirrored)
-Short Wall Section 1st Floor
-Short Wall Section 1st Floor (Mirrored)
-Ruin Wall 1st Floor A/B (These pieces are optional and the fitment may take minor filing in the gaps where they glue into the columns. I mis-measured, but they work fine.)

SECOND FLOOR:
-Balcony Section
-Door Panel 2nd Floor
-Long Wall 2nd Floor
-Long Wall 2nd Floor (Mirrored)
-Ruined Wall 2nd Floor A
-Ruined Wall 2nd Floor B
-Floor Section 2nd Floor (This will fit diagonally across an Ender 3 buildplate, or similar)

ROOFTOP:
-Column Cap (x2 - Optional)
-Crenellation Center_Pillared
-Crenellation Right
-Crenellation Left
-Floor Section Rooftop