AC-S Ancient Carnivore Autocannon Sponson

This is a sponson-mounted long-barreled kinetic weapon for the Ancient Carnivore battle tank.

It comes in five parts:

-The weapon itself
-The sponson mount with the mounting pin for the weapon
-The top bracket for the sponson mount
-The targeter for the weapon
-An optional gun shield

The sponson mount has a built-in socket for a 5x1mm disc magnet.

You'll need to assemble the sponson with a bit of superglue.

-Place the gun by its bottom socket on the sponson's mounting pin - note that the side with the magazine/power cell should be on the side facing AWAY from the vehicle
-Glue the sponson's top plate in place with a drop of superglue on the top of the sponson mount
-Glue the targeter to the socket at the top of the gun, threading the pin through the hole in the top plate. Note that the targeter pin has a little tab on it so it'll only go in with the sensor lens aligned with the gun barrel.
-Glue the gun shield onto the sponson mount.

The sponson and targeter pins should keep the gun firmly attached to the sponson mount without actually gluing it into the mount itself, giving you some horizontal traverse. The intended magnet attachment provides vertical traverse.

The sponson body, targeter and sponson top plate are symmetrical and can go on either side of the vehicle. You'll want to print two copies of everything and mirror the weapon and gun shield to get a matched pair for your vehicle.

Note that the example picture uses the optional Tech Shield and Targeter for an alternate look.

This is intended to be printed with a SLA printer, with 0.05mm or lower layer height.