IKEA SVALLET Wall Mount Conversion

The IKEA Svallet lamp is nice looking and cheap (in Poland about 15 PLN, ~4.1 USD).

Unfortunately, in my opinion, these are its only good points.
I bought it as a desk lamp, but the lack of any adjustment is a big problem.Most light bulbs stick out, so the light is too strong and hurts the eyes.
It stayed unused for a long time. After moving to another apartment, I needed a reading light above my bed.So I decided to modify it into a wall lamp, keeping the original lampshade.

To mount it, you only need two 6x40 mm hammer fixings.

The lamp can be rotated about 90 degrees —from a right angle: 20° up and 70° down.

• Do not print with a nozzle bigger than 0.4 mm. The teeth will be too smooth and the lamp will not hold its position.
• Layer height: up to 0.32 mm. I recommend 0.2 mm layer height for a 0.4 mm nozzle.
• Material: PLA (printed on Bambu Lab A1 using Bambu Studio slicer) For better durability of the teeth, you can also use ABS or ASA.

All my models are also tested on a problematic Ender 3,
using default Cura slicer settings — to make sure they print well even on older printers.