Étui pour Iphone 17 - V7 - MAGSAFE

Great design, but unfortunately not very practical in real use:
• The fit is a bit loose, although this can be corrected in the slicer by scaling the model down to about 99.9%.
• The bottom wall (the part above the MagSafe ring) is too thick — 1.2 mm. Because of this, the magnetic strength is noticeably weaker. It would work much better if the overall bottom thickness was reduced to 1.8 mm with a 0.8–1.0 mm recess for the ring.
• However, the biggest issue is misalignment of the MagSafe recess. It is significantly offset compared to the original Spigen case, which causes two problems:
• MagSafe charging does not work because the magnet is not centered over the coil.
• Magnetic grip is much weaker than it should be.

For testing I used a strong original MagSafe ring taken from a Spigen Ultra Hybrid case, and I confirmed that the issue is not the magnet but the recess position in the model.