闪电杖灵感道具鳕鱼僵尸起源杖

this cosplay and display prop was inspired by the iconic Lightning staff from call of duty zombies ! the files are high quality and designed for easy printing, some extra bits like pvc pipe and wood dowel is required to fully recreate one of these awesome props ! these files are split up for large format 3d printers so further slicing may be required to fit on your machine ! IThese are the simplified, diy friendly files, not my personally used files. If you are looking for more functional files that require a bit more tinkering, tedium, and craftiness but also allow for the breaking apart of the staffs, the usage of metal rods and tubes for strength, and the inclusion of leds and moving parts on the heads you can send me a message over my email where we can discuss further ! (theapropalypse@gmail.com)

Required extras !

1x 42inch long .5inch diameter pvc pipe for body shaft

5x 4.75inch long .25inch diameter wood dowel rods for circling the coil section

Small screw or pin for attaching trigger

4x .25inch diameter 2inch long wood dowel for strengthening connection between the head and bolts

2x .5inch diameter 2.5inch long wood dowel for strengthening connection between the head and crystal base

1x .25inch diameter 4.25inch long wood dowel for suspending halo around crystal

10x3mm magnets for attaching upgrade spikes. (magnets make them more likely to fall off rather than break off

print parts with desired settings, supports will be necessary.