变形金刚最佳擎天柱大腿升级版

Parts to give your original Beast Wars Optimal Optimus rotating thighs.

Install by removing the original thighs and installing the printed parts. The ratchet tabs from the original thigh will be required.

Some additional hardware is also needed for assembly:
2x M3x20 mm screw
4x M3x14 mm screw
2x M3x6 mm screw

Getting longer screws and trimming them down also works.

bwtm-opop-04-02-01 & bwtm-opop-04-04-01 (lower thigh pieces) have no opposite part, print 2 copies.

See images for assembly instructions.

With all pieces, sanding may be required for a good fit, depending on your printer and settings. Paint may affect final fit. Wear on mechanism may affect part interaction.

This model is not to be uploaded or sold in any form and is intended for personal use only. Other file formats may be made available upon request.

I printed this model in 1.75 mm PLA Plastic, with a .4mm nozzle filament printer. Support material required. Different print orientations may vary results, sanding may be required after printing.