任务流系统

When I saw this, I knew I had to make it! I made a 6x6 grid for 6 columns, that are divided into two workflows with the same columns. The Input Task Slots, 12 of them, took 25h to print, the Task Extensions, 18 of them, took 39h to print. Column headers, 8 of them, took 4h to print. The Pen Holder I had to print twice, the first time I printed it flat and the supports underneath were a nightmare. I printed it standing on end and it printed flawlessly and it was a 3h45m print. All of the other header prints took about 4h to print. All told, the whole project took about 77h to print and about 1350g of filament. I printed everything with Sunlu +2.0 White, everythings sliced in Bambu Slicer.

One thing I ran into with this design is the tape I used to cover the Task Chips really works best with writing with a Gel Pen. I tried using a dry erase board marker, but found that when I repeatedly put the task chip down the input slot, it would wipe off part of the writing. When I use a Gel Pen, that doesn't happen.

If I were to print this project again (which I probably will in the future) I'd change the infill on the Task Chip to something more dense and increase the infill to 65% so that it doesn't bend as much when removing it from the column. The Task Chips really need to be a bit more stiff...maybe printing them in PETG or ABS would help?