- 12 мне нравитсяs
I love this design and so many people don't realize they should add unmelted filament to the design.
I sliced in Cura. Print time was roughly seven hours.
My print has some blemishes, BUT I believe it's from moisture in the filament.
It's been raining for days! Humidity in my print room was 49% with a temp of 11C (52f).
I built an enclosure as the print progressed and by the 50% mark I had it in place and temp was UP while humidity was DOWN.
- Raft: Нет
- Решение: 0,12 mm
- Температура: 205 ℃
- Поддержать: Нет
- Заполнить: 100 %
- Скорость: 40 mm/s