PlugHack | Mini DockingStation | Smartphone

You don´t know where to put your Smartphone during charging?

Or...

One of your prior phones fell down to the ground and your display was broken while charging?

Then it´s time to print your own PlugHack!

PlugHack is a mini dockingstation for your smartphone.
It´s designed to fit for most common chargers, microUSB´s and phones.
Your phone can´t fall down if the microUSB is SAFE connected to it.

PlugHack is printed in 4 Parts:
- PlugHack itself
- Screw M6
- Screw M12
- Clamp

The first part should be printed in the position that the last picture shows. Otherwise the thread will not work (at least with my printer).

#LIFEHACK3D

Settings for the PlugHack:
- Layer Height: 0.1mm (otherwise the thread will not function)
- Print Speed: 60mm/s
- Support Overhang Angle: 70° by very efficient cooling; otherwise 60°

It´s important that inside the thread should not be any support.

Screws:
- Layer Height: 0.1mm
- NO support
- Print Speed: 50-60 mm/s

Time: about 6h

Printed with a Creality-Cr10