Outlet Phone Holder with Cable Management

I once saw a smartphone holder in a shop somewhere and then I realized that I could make a custom one. This cable holder also holds your cables in the bottom, so they are not dangling in the air. This makes the design also a lot safer, so you don't tear down your smartphone by accident.
Furthermore, was the design made specially with 3D printing in mind. There is NO need for supports, when you print this. Just make sure, that the part that goes over the outlet lies flat on your building surface!
This size works for almost all smartphones. It was tested with a 6.3 inch phone which ways 200 grams.

My Cura Settings:
- NO supports
- 30% infill
- 3 wall thickness, so the holder is robust enough and does not bend
- printing time around 3.5 hrs, depends on your printer