Christmas Soap Dispenser

Holiday soap dispensers for use with a Dial pump(not the foaming pump).The snowman printed fine but I haven't printed the tree yet and I am not sure I will. Note: This is more of an experiment to see what happens to pla when in contact with regular hand soap. I will keep this updated with what I find. If you try this as well or if this has already been done please let me know. Thanks and enjoy.

Printer Brand:

Printrbot

Printer:

Simple Black

Rafts:

Yes

Supports:

Yes

Resolution:

.2

Infill:

15

Notes:
I used MatterControl for this print.

I changed Outer Surface Perimeters Count to 3.
Support Material Amount Minimum 20 degrees.
Turn on Support Everywhere - This should produce some support on the inside.
Temp 199.

The snowman you could print at 100% infill but I would print the Christmas tree with 15-25% infill because the inside is dished and 100% would use a ton of filiment.

Post-Printing
I used a screw driver to knock loose the support material and long needle nose pliers to pull it out.

Threads fit the pump from a regular Dial 7.5 ounce soap dispenser (Not the foaming pump)
I trimmed about 1" off of the bottom of the tube on the pump