Aller au contenu

Makes réalisés par la communauté

Vous avez imprimé en 3D ce modèle ?

Soap holder

Description du modèle 3D

Porte-savon

Paramètres d'impression 3D

Porte-savon

  • Format du fichier 3D : STL

Mots-clefs

Créateur

Abonnés 131 Abonnements 0
Téléchargements 8242

+LAB is the new 3Dprinting lab of Politecnico of Milan. Our team is composed by designers and engineers conducting academic research on this amazing technology!

License

CC BY NC SA

Page traduite par traduction automatique. Proposer une meilleure traduction

Fichiers 3D similaires


Ajouter un commentaire

4 commentaires

I've tried to print this twice (v2) and after it gets down with the bottom (approximately) my printer kind of goes nuts and tries to over-adjust and then essentially, it is offset by about 2 inches and tries to continue printing, but obviously it can't because it is not continuing where it left off and is basically printing over open air, so strings are going everywhere and don't have anywhere to connect. I've never had this issue on other prints.

@ClaudeJanz @nhabbott You're right, sorry for this problem. There is now the good file and a V2 of the Box, you can download the creation again to get them.

Same comment as nhabbott: the plate hase no holes in it.

Could you send me the plate with the pattern .stl files?