Bunny Cable Holder

This adorable Bunny will hold your favourite cable with commitment. Can't be cuter than that!
Perfect for your smartphone, iPad, iPhone cables.

Use it wherever you need a little friend to hold your cable: Desk, Table, Kitchen counter, Nightstand or Car Dashboard. At home or the office!

Guaranteed 100% Kawaii! (✿◠‿◠)

Your cable will not fit if it exceeds 4mm diameter!
Make sure you don't want to use it for a large cable. Tested with Apple chargers, Samsung chargers, USB-C and USB-A cables.

If you want to to fit a larger cable, just increase the scale of the bunny until it fits your needs.

Si vous désirez vendre des impressions 3D basées sur mes designs, rendez-vous sur Patreon pour obtenir une license commerciale:
www.patreon.com/holoprops

Tous mes designs sont couverts par une licence Creative Commons non-commerciale. La vente d'impressions utilisant mes créations m'appartient intégralement, ainsi qu'à mes Patreon actifs. S'il-vous-plaît, veuillez comprendre que chaque création représente des jours de travail et de multiples impressions de prototypes pour assurer un super produit fini. Merci à tous et Happy Printing!

To get the best out of the STL files, please follow these guidelines:
• Layer Height 0.2mm
• No supports needed, but use a raft for the small parts (eyes, blush and mouth)
• Nozzle 0.4mm
• Recommended infill 20%.
• Do not print over 50 mm/s. A lower speed like 40 or even 30 mm/s will always produce better results.
• Make sure your bed is correctly levelled. Then check again :D
• Try to hide the seam and place it in the back of the bunny where nobody will pay attention.
• Make sure your printing temperature and bed temperature is adequate for the filament you are about to use.
• If you follow the recommended settings above, you do not need any supports to print the body.

Please, tag me on Instagram (@Holoprops), I would be thrilled to see your results in all kinds of colors.

Happy printing!
PH from Holoprops