Aller au contenu

Pièce de poignet Xenos Hater

?
Qualité du make : 0,0/5 (0 votes)
Évaluation des membres sur la qualité de l’impression 3D, du post-traitement, de la photo, etc.
Maker
Fichier 3D

Description du Make

The Wrist-Piece really helps to give my all-new Primaris Librarian Watch Master (you can never have too many titles, right?) the right feel.
I slightly modified it while mesh-bashing in Meshmixer to accommodate the shoulder pad (removed the elbow thingy). The pointy bits are quite delicate, but printable if supported correctly (i.e. many but quite thin supports). I unfortunately do not remember the scaling factor, I just tried until it look right.

Imprimante 3D

Anycubic Photon Mono
  • Résolution : 0,05 mm
  • Support : Oui

Ajouter un commentaire