The detail of this model is very impressive.
I used Overture Rock PLA to print it. The 'Rock' PLA has a matte finish, and black specks in it to simulate stone. I was worried about my 0.4mm nozzle, but I had no problems with clogging during the 26 hour print.
The Rock PLA did not stick well in the PEI sheet, but worked fine with the Powder Coated sheet. I used the default PLA settings and enabled supports. And I'd recommend using a brim, I had to reprint one of the wing tips, because it broke loose on my first try
I also scaled the model to about 45%, which resulted in a 220mm tall statue.