Aller au contenu

Recreus sandals

?
Qualité du make : 5,0/5 (1 vote)
Évaluation des membres sur la qualité de l’impression 3D, du post-traitement, de la photo, etc.
  • 5 j'aimes
Maker
Fichier 3D

Description du Make

I printed these for my daughter as an experiment with TPU. No supports, but a lot of drooping around the toe area of the shoes. I measured her foot and a couple pairs of her shoes and printed at 75.51% scale to get 195 mm in length. They are a little rough on her ankles, so added some moleskin for padding.

Imprimante 3D

MakerGear M3-ID Rev. 1

Filament

Hatchbox Red TPU
  • Raft : Non
  • Résolution : 0,2 mm
  • Support : Non
  • Remplissage : 25 %

Ajouter un commentaire

2 commentaires