Printed with PLA with 0.2mm layers, 0.4mm nozzle, 2 outer walls (as specified) on Ender 3 pro with glass bed and direct drive mods. All the parts fit on the 220mm^2 build place with plenty of room. Total print time was about 9 hours.
Overall the print was excellent, and the design is obviously high quality. The part fits onto a Switch Pro controller snugly.
The main issue I had with the print was elephant's footing. I typically experience elephant's foot with my prints. This was resolved by filing the edges that touched the build plate. Without filing the edges, the brackets and clips would not properly snap into place.
In the future I would print with PETG, at least for the retainer clip parts. I expect the PLA parts to eventually fail due to the repeated bending stress and shearing on the locking nubs.