Tiroirs d'imprimante pour table basse Ikea

The printing of the drawers tends to "warp". Apart from that, the printing succeeds without problems.

The design itself is rather poor: If you want to insert or remove the drawers, you have to use brute force. The flat drawer (drawer 2) must be inserted before the supports are mounted on the table. The terse note in the assembly instructions is misleading!

For an easier installation of the drawers, fit the support altogether with drawer 2.

It is not about easing the assembly - it is simply the only option!

After assembly, the drawer 2 can not be removed without dismantling half the structure. The other drawers can also be removed only by force, as already mentioned above. In the long run, the screws will tear out of the tabletop for sure.

Overall a disappointing design.