Aller au contenu

Fusée gCreate

?
Qualité du make : 5,0/5 (1 vote)
Évaluation des membres sur la qualité de l’impression 3D, du post-traitement, de la photo, etc.
  • 13 j’aimes
Maker
Fichier 3D

Description du Make

I made it into a night light, and added a base for the power switch and the cord. The power supply, switch and connector, came from an old USB disk drive case.

I hogged out the inside of the rocket, printed a cylinder to stick the LEDs to and glued it in. There are also some LEDs around the inside of the nozzel. There wasn't enough room to route the wires between the rocket body and the nozzel, so I ran the wires outside and made them look like hoses.

Also, I used Meshmixer to split the rocket body into 3 parts, so I could print it without supports. It is all PLA and I hope to paint it soon. McMaven.

Imprimante 3D

Prusa Mk3

Filament

Hatchbox
  • Raft : Non
  • Résolution : 0,15 mm
  • Température : 195 ℃
  • Support : Non
  • Remplissage : 5 %

Autres makes du même modèle 3D


Ajouter un commentaire

Un commentaire

Man! This is awesome! Can you share your stls? i don't know nothing about cuts and meshmixer hehehe