Aller au contenu


Qualité du make : 5,0/5 (1 vote)
Évaluation des membres sur la qualité de l’impression 3D, du post-traitement, de la photo, etc.
  • 8 j’aimes
Fichier 3D

Description du Make

This is a perfect model for Easter or for whenever you're having a boiled egg.

Note that I first had trouble with the bottom of the cup. At 5% cubic infill there was just nothing to put a bridge on and Slic3r didn't detect this. It just happily tried to print a bridge and the following layers in mid-air. Eventually it recovered but the purple print still has a little hole in the bottom.
For the pink one I changed to 10% rectilinear infill and looking the preview I made sure the bridge would be supported by the infill. This ensured a perfect bottom.

Time to print: ±3.5h
Slicer: Slic3r PE 1.41.3

  • Raft : Non
  • Résolution : 0,16 mm
  • Température : 205 ℃
  • Support : Non
  • Remplissage : 10 %
  • Vitesse : 70 mm/s

Autres makes du même modèle 3D

Ajouter un commentaire