Calvin et Hobbes
?
Qualité du make :
0,0/5
(0 votevotes)
Évaluation des membres sur la qualité de l'impression 3D, du post-traitement, de la photo, etc.
Votre note :
0/5
- 2 j'aimes
Maker
Fichier 3D
Description du Make
S3D
Imprimante 3D
Wanhao Duplicator 9Filament
PLA and PETG- Raft : Non
- Résolution : 0,2 mm
- Température : 190 °C
- Support : Oui
- Remplissage : 10 %
- Vitesse : 50 mm/s
Autres makes du même modèle 3D
Ajouter un commentaire
4 commentaires
That's odd about Calvin's hair. Hobbes definitely needed some supports but Calvin shouldn't have. I guess that there are so many variations of printer, filaments and print settings that everyone's experience will be different.
I appreciate the feedback and will take this into consideration on my future models.
One question, did you use PETG or PLA on Calvin's hair?
FYI-I use a max overhang angle of 60% for my supports needed or not determination.
Thanks,
Steve
I needed supports on the head of Hobbes and the hair of Calvin.. Tried several times without but then they failed. Even with the supports it went not as smoothed as I wanted...
Great job on this model!
I see you listed supports required. Did you only need the small supports for the one piece or did you need more than that?
Thank you for posting your make!
Teamwork,
Steve
Calvin's hair is PLA. Only PETG used in this model is the trousers of Calvin. Was the only black I had..