Ir al contenido

Atención amigos, esto no es un mensaje privado sino un hilo de discusión público. Es un lugar de intercambio, gracias por ser cortés y respetuoso. Cualquier solicitud comercial o maliciosa será eliminada. Si mencionas un diseño en particular, no dudes en añadir el enlace o el título del diseño en tu mensaje para que la conversación pueda ser dirigida adecuadamente. Si quieres adjuntar fotos a tu post, no dudes en subir tus imágenes a un servicio gratuito de alojamiento de imágenes en línea como Imgbb y copia/pega los enlaces a tus imágenes en tu comentario. Tengan una buena discusión!

Escribe tu mensaje:

9 commentarios

I purchased this setup for a long wheelbase truck that I'm building... can you provide a few more angles of the install to see the shock tower placement?

hey just wondering what little light bar you used for the bed rack? just bought the files and looks great

Its a Capra light bar that I cut down to fit. I cut a section out of the middle of the housing and cut a few of the LEDs off the end of the board.

JACOBOHARA, I did design the rear trailing arms in the pictures. The ones in the pictures had a design flaw at the axle mount end and have since been replaced, I don't have the design shared anywhere at the moment but can put it up on Thingiverse.

SCHNIPEXX, I don't have the truck set up with the I-Beam suspension anymore, and unfortunately I don't have any top down pictures of the suspension. The servo in that picture was attached to the servo mounts which I believe need to have holes drilled through them into the top of the suspension arm mounts to bolt them down, it's been so long since I changed it that I don't remember exactly how I had it set up.

Hello,

I really like your twin I beam suspension! I noticed you have the rear trailing arms too! is this a file you made or found? If so is it available?

Thank you,

Regards
Jacob

hi. Very nice job. Have a picture from above. how is the servo attached ???

How much would you charge to print out 3 of these twin I beam kits? My number is 971-237-6267 my name is Ben. Thanks

On the vehicle pictured the mount is bolted into one of the shock tower holes, the vehicle is lifted so the shocks are bolted to the frame instead of the shock towers. If your vehicle has shock towers installed then you will need to mount it somewhere else along the frame rail (likely need to drill a new hole) or cut off the upper tab so you can bolt it on over the shock tower.

Hola buenas tardes
Primero de todo darte las gracias por tu archivo para hacer el soporte para la barra panhard.
Mi pregunta es como va montada la pieza en el chasis?
Podrías mandarme fotos para ver como lo tienes tú montada ?

Gracia