Ir al contenido

Arti-Brachi

?
Calidad de creación: 4,9/5 (7 votos)
Evaluación de los miembros: imprimibilidad, utilidad, detalles, etc.
  • 26k vista
  • 92 me gusta
  • 216 descargas

Descripción del modelo 3D

How long can you print this Dino?

No supports required. Just slice and print!!

After printing, just move the articulations and assemble the tail (Post printing video here)

Check my other articulated designs here!

Parámetros de impresión 3D

Can be scaled up or down (the limit is up to your printer capabilities).

A good first layer is mandatory for the print to success. Be sure your printer is calibrated and you have good bed adhesion.
Good layer cooling is also recommended, as it prevents curling and warping on overhangs.

  • Formato de archivo 3D: STL
  • Fecha de publicación: 2021/03/03 13:26

Palabras-clave

Creador

Copyright

©


Makes hechos por la comunidad

Los más vendidos de la categoría Juegos


Añadir un comentario

6 comentarios

Awesome!! Feel free to share some pictures ;)

All good. I had the wrong slicer settings. Came out great.

Well, it depends on your failure type.
If you don't need a very strong print, as in my case, infill is not required (you can see a timelapse here: https://youtu.be/Vh_yflrPcZs). However, if you are going to manipulate the figure, at least a 15% infill is recommended. But this should not influence the failure.
Same for the shells. I printed them with 2 shells and default values for top and bottom (5 and 4 layers respectively). Increasing the number of shells gives you a stronger print, but it should not be the cause of a printing fail.

I will check again. So no innfill required? What about shells and bottom and top layer

Oh, I'm sorry to hear that. What kind of fail do you have? Have you printed articulated models before? The most common issue in these articulated designs is caused by poor layer cooling, which causes the layers to curl/warp on the articulations, and then the nozzle collides with that piece and releases it from the bed. If that's the case, ensure you have the layer fan at 100% and the airflow is good (some printers have a bad stock fan duct). Enabling the z-hop at 0.2-0.4mm also helps to avoid collisions.

If you have any pictures you can send them to me at mcgybeer@gmail.com so I can better assist you.

I purchased the arti-brachi-dinosaur, but can't get it to print. first layer is great. any suggestions about infill, shells etc?


¿Te gustaría apoyar Cults?

¿Te gustan Cults y quieres ayudarnos a continuar la aventura de forma independiente? Tenga en cuenta que somos un equipo pequeño de 3 personas, por lo que es muy sencillo apoyarnos para mantener la actividad y crear futuros desarrollos. Aquí hay 4 soluciones accesibles para todos:

  • PUBLICIDAD: Deshabilite su bloque de anuncios AdBlock y haga clic en nuestros banners.

  • AFILIACIÓN: Haga sus compras en línea haciendo clic en nuestros enlaces de afiliados aquí Amazon, Gearbest o Aliexpress.

  • DONACIÓN: Si lo desea, puede hacer una donación a través de PayPal aquí.

  • PALABRA DE BOCA: Invita a tus amigos a venir, descubre la plataforma y los magníficos archivos 3D compartidos por la comunidad!