Ir al contenido

House of El crest

Descripción del modelo 3D

Encanto esférico con una casa grabada de la cresta El. Puede ser utilizado como pendiente o un encanto de la cadena dominante, o cualquier otro tipo de encanto.

Parámetros de impresión 3D

Bellow are the recommended settings for best print result. I have provided build files that can be used directly on your printer in the following formats in case your slicer does not have all the below options (.gcode, .x3g, .makerbot, .3w) I have also included the .factory file for Simplify3D Slicer.

Process Settings

Model Size: 40 mm Diameter, Scaled to 30 mm for this print

- Height: 0.1 mm
- Top Solid Layers: 10 minimum if you are using less than 50% infill, this will insure the top of the sphere does not cave in.
- Outline/Perimeter Shells: 4

- Extruder: 230 C (When using ABS filament)
- Heated Build Platform Temp: 105 to 110 C (When using ABS filament)

- Raft Layers: 3
- Raft Offset from part: 3.00 mm
- Separation Distance: 0.14 mm
- Raft Infill: 85%

- Interior Fill Percentage: 15% Minimum
- Minimum Infill Length 5.00 mm

- Support Infill Percentage: 25%
- Dense Support Layers: 3 Minimum
- Dense Infill Percentage: 80%
- Support Pillar Resolution: 2.00 mm

Note: I have raised the model a few millimeters above the build plate and let it print directly on the support pillars, I have found that this approach allows for a better printer sphere, but requires some post print processing (sanding and smoothing). however, you can still get good results printing directly on the build plate and without a raft.

  • Formato de modelo 3D : STL y ZIP



Seguidores Suscriptores 0
Descargadas 5867
Ventas $27

3D Printing and Modelling currently in Kuwait and Lebanon. open for requests

Instagram : Exfusion3d



Página traducida por traducción automática. Sugerir una mejor traducción

Modelos 3D similares

Los más vendidos de la categoría Joyas

Añadir un comentario