Ir al contenido

Fortaleza de Martillo de Guerra de la Torre de Dados de Sacrificio

?
Calidad de make: 0,0/5 (0 votos)
Evaluación de los miembros sobre la calidad de la impresión 3D, post-procesamiento, foto, etc.
Maker
Modelo 3D

Descripción del Make

Took over a 3 days of printing and had a couple small issues but over all it came out great. Used Cura 4.1 as the slicer and printed the base upside down and the tower sides flat on their backs. Getting the supports off the base was a pain because of how it ended up wrapping around the ramp roof. Ended up haveing to just stab and tear away chunks of it at a time until I was able to pull it out.

Impresora 3D

Ender 5

Filamento

Sunlu Gray
  • Raft: No
  • Resolución: 0,2 mm
  • Temperatura: 200 ℃
  • Soporte: Si
  • Relleno: 10 %
  • Velocidad: 80 mm/s

Otras makes del mismo modelo 3D


Añadir un comentario

Un comentario