Ir al contenido

La pesadilla antes de Navidad - Diorama

?
Calidad de make: 0,0/5 (0 votos)
Evaluación de los miembros sobre la calidad de la impresión 3D, post-procesamiento, foto, etc.
  • 1 me gusta
Maker
Modelo 3D

Descripción del Make

I needed up concerting this scene into a lid for a jewelry box for a friends birthday gift. Looks pretty good I have to say! It’s scaled down to 60% and I added a block to the bottom to keep it on the box I designed.
The lid took about 5 hours and all told the print took about 14 hours though it might be less then that if I didn’t have a few print failures. I honestly don’t think I would have had so much trouble if I had kept it the full size. But couldn’t fit that on the build plate so...
Note the part I had trouble with was the curl which is separate. It’s just a difficult shape to support even separated from the full scene. I also tried to add jack skellington but he was just to delicate with the setting I was using. I also kept the moon off so I could print that in a different color.
The infill number is not right cause I hollowed it using chitchu box and I don’t know what % that would be for resin printing. Same for the temp

Impresora 3D

Anycubic photon
  • Raft: No
  • Resolución: 0,05 mm
  • Temperatura: 100 ℃
  • Soporte: No
  • Relleno: 10 %
  • Velocidad: 55 mm/s

Añadir un comentario