Ender 3, 3 V2, 3 pro, 3 max, doble ventilador axial de 40 mm conducto / colmillo. CR-10, accionamiento directo Micro Swiss y compatible con bowden. No se necesita soporte para la impresión

Briss Fang with LEDs, nil bed sensing hardware. Printed upside down as suggested, with tree supports, 195/45°C, Cura, stock firmware, approximately 10 hours. Went with Noctua NF-A4x20 PWM 4020 fans for both, and the noise difference is HUGE. Initially thought the printer was dead when I turned it on, because it's so quiet. Highly recommended.