Ir al contenido

Torre de dados dimensionada para impresoras de resina

?
Calidad de make: 0,0/5 (0 votos)
Evaluación de los miembros sobre la calidad de la impresión 3D, post-procesamiento, foto, etc.
  • 2 me gusta
Maker
Modelo 3D

Descripción del Make

Failprint. I printed the Open Tower in One Piece. The problem was being able to unstick the model from the base after 10 hours printing.I was using 45s/bottom exposure and 12s/normal exposure I needed to use so much force than the delicate jardin cracked. Also noticed it is not possible to fully cure this model with solar light only using opaque resin. Probably will try again with translucent resin and printing in two pieces.

Otras makes del mismo modelo 3D


Añadir un comentario