Ir al contenido

COVID-19 MASK (Easy-to-print, no support, filter required)

?
Calidad de make: 4,5/5 (1 voto)
Evaluación de los miembros sobre la calidad de la impresión 3D, post-procesamiento, foto, etc.
  • 3 me gusta
Maker
Modelo 3D

Descripción del Make

Easily scalable took a few hours to print the main mask part used supports to make sure it all printed well at the layer hight i was using, I don't think it would have needed any.
This is a great design , thanks for uploading it. :)

Filamento

PLA
  • Raft: No
  • Resolución: 0,35 mm
  • Temperatura: 190 ℃
  • Soporte: Si
  • Relleno: 25 %

Otras makes del mismo modelo 3D


Añadir un comentario