Ir al contenido

PrintrBot NinjaFlex Upgrade

Descripción del modelo 3D

Read the full installation guide on:

NinjaFlex is our favorite TPE based filament becuase it works great with our wearable projects.

If you've ever tried printing ninjaflex on a PrintrBot, you may have notice a small problem. It doesn't extrude so well. TPE material is so flexible that the filament actually buckles just before reaching the hotend. The drive gear and the hotend are so far apart that the filament can actually tangle!

Our 3D printed filament upgrade eliminates this problem by guiding the filament directly to the drive gear, removing any room to buckle.

Designed to print right on your printrbot in just ten minutes, the installation is easy and requires no extra parts.

Parts list:
On/Off DC Barrel
Extension cable

Parámetros de impresión 3D

PLA or ABS @230
.2 Layer Height
2 Shells
10% Infill
90/90 Speeds

for ABS heat bed to 120


Adafruit was founded in 2005 by MIT engineer, Limor "Ladyada" Fried. Her goal was to create the best place online for learning electronics and making the best designed products for makers of all ages and skill levels. Since then Adafruit has grown to over 25 employees in the heart of NYC. We've expanded our offerings to include tools, equipment and electronics that Limor personally selects, tests and approves before going in to the Adafruit store. We pride ourselves on having great prices, the best customer service, technical support and fast shipping. We hope we can assist you on your journey of learning - At Adafruit we celebrate engineering happiness!




Creaciones similares

Añadir un comentario