Ir al contenido

PLA Spool Mount

Descripción del modelo 3D

This is an alternative spool mount for the Makerbot Replicator 1 (for wider spools with smaller holes).

Just yesterday I visited the fablab in Utrecht (Netherlands). And they had a lot of Ultimaker printers working with PLA. And well... the air was a LOT fresher than in my studio when I print with ABS. Since I already had a roll of PLA, I decided I wanted to give that a go.

Sadly.. the roll was a different size than the ones from Makerbot. So I figured I'd use some of the ABS I still had mounted to create a new mount.

This mount is much thinner than the original ones on my Makerbot Replicator 1.
It works with rolls that have a hole diameter of 3 centimeters (1.18inch)
And the roll has to be 9cm thick (3.54inch)

I included my Blender 3D file so it's easy to modify the source to fit whatever roll you need. I printed it in two halves and there are some small holes in the design to attach the halves using

Parámetros de impresión 3D

Print both parts, then attach them using 2 small tie-wraps.





Creaciones similares

Añadir un comentario