Ir al contenido

Stubby Ghost Door Stopper

Descripción del modelo 3D

Stubby is a remake of a 3D file created by another member on Thingverse and therefore is not an original design although the modifications I made make it shorter and fatter than the original and I also removed some areas in the original author's work.

Parámetros de impresión 3D

I left Stubby in the vapor bath a little too long and his arms started sagging into a pool of blood so be carefull and don't repeat my mistake.

My door bottom is 34mm above the floor, so Stubby fits nicely there now and wards off other ghosts who have been known to haunt this house.

I printed this at .3mm with 20% infill. I usually only leave an object in a cold vapor bath for 2 hours, but this one was left too long and started to sag.






Creaciones similares

Añadir un comentario