Ir al contenido

Fun with Photo Frames

Descripción del modelo 3D

​I thought that a picture frame would be perfect design to try out my woodfill PLA. I tried staining it and then I printed in bronzefill, translucent and regular PLA. This easy print comes in two variations. Both are sized for 3.5 x 5 inch photos. There are two holes to facilitate hanging horizontally or vertically. There is an inner ledge that will hold a piece of glass and the photo and/or photo and a piece of cardboard. The first one I designed was a tad too big for my Lulzbot mini so I trimmed it around the edges. All of the photos display the mini version except for the grey one which is a bigger frame but thinner overall. You don't even need to hang them on the wall as you can see I used my phone stand in one of the photos.

Even though these are not printed in NinjaFlex I'd like to let you know I sell small starter spools on my website for 9.99 , Amazon Prime (12.99) and eBay should you like to try out a flexible filament or get one of the 26 available colors. Thanks!

Parámetros de impresión 3D

PLA settings 185 - 210


We developed a great way to distribute cost effective quantities of flexible filament: Splash Spools. A generous amount of filament on a spool with a case so it's not flopping all over the place. Splash Spools store easily in a desk drawer, stacked space or even hang on a wall. Available on and Amazon. We stock NinjaFlex, Cheetah, SemiFlex, SainSmart, Fillamentum and our own brand Flexy.




Creaciones similares

Añadir un comentario