Skip to content

Caution friends, this is not a private messaging but a public discussion thread. It is a place of exchange, thank you for being courteous and respectful. Any commercial or malicious solicitations will be removed. If you mention a particular design, feel free to add the link or the design title in your post so that the conversation can be properly directed. Have a good discussion!

Write your message:

4 comments

I know it's been a while since you uploaded your ring designs but I was hoping you were still around. I'm attempting to print on a Creality Ender 6 with no luck whatsoever. I've tried every setting I can think of but it seems like the slicer doesn't know how to cut these up. At best little to nothing prints and then it moves 7-10mm up and attempts to print in thin air, at worst I get spaghetti caused by the mad morse code-like jabs and jerks that eventually snag the raft and/or whatever else may have printed on the bed. Any insight or suggested settings would be greatly appreciated. Thanks!

Hi,
I am interested in your designs, can you get in touch with us on ceo@aestrix.in to discuss further.