Skip to content

watch stand - tilt -

3D model description

tilt is a watch stand. (It depends on the kind of watch.)

Easy Kimekomi by outputting a 3D printer!
(full cover Kimekomi Body)

3D printing settings

It has become a model of support basically unnecessary.

It has become a model that assumes the output at a 3d printer fdm method.

There is a case where the output can be difficult depending on the type of slicer and 3d printer.

The output product by direct, indirect damages can not be held responsible in any case.

You need acrylic bar of about φ5x30~40 other.

Image of 1-3 piece is in condition to have a Kimekomi.

The fourth image is the shading data state.
(With some support (red part))

Accessories in the image is not attached.

Please refer to this material, tool, work in regard to the steps required Kimekomi.

sample Parameters(Material_PLA)
Layer Thickness_0.32mm
Skin Thickness_1mm

About size 67x64x58 mm


I have been creating works using a 3D printer.
I have created a work that combines Kimekomi method which is used in the traditional crafts of Japan.




Similar creations

Add a comment