This is a custom foregrip for Airsoft and Paintball markers.
This is the most advanced design I have done to date, and It was designed with practicality and ergonomics in mind.
This design, prints in one piece and only requires a 3/16" x 1 1/4" screw. To mount it you need the appropriate 3/16" tap since you need to thread the mounting hole.
Supports are needed for this print.
DO NOT USE WITH REAL STEEL FIREARMS. I take no responsability for any harm taken or done for not following these instructions.
Only 30g. of plastic
ABS: May need to account for plastic shrinkage 100.3% scale +,-.1
Infill: 15 (at least)
Layer height: .2
Use 25% infill