Skip to content

Winged Victory of Samothrace

?
Make's quality: 0.0/5 (0 votes)
Evaluation of members on the quality of 3D print, material, post-processing, photo, etc.
  • 1 like
Maker
3D Model

Make's Description

The detail of this model is very impressive.

I used Overture Rock PLA to print it. The 'Rock' PLA has a matte finish, and black specks in it to simulate stone. I was worried about my 0.4mm nozzle, but I had no problems with clogging during the 26 hour print.

The Rock PLA did not stick well in the PEI sheet, but worked fine with the Powder Coated sheet. I used the default PLA settings and enabled supports. And I'd recommend using a brim, I had to reprint one of the wing tips, because it broke loose on my first try

I also scaled the model to about 45%, which resulted in a 220mm tall statue.

  • Resolution: 0.4 mm
  • Temperature: 205 °C
  • Infill: 15 %

Add a comment