Skip to content
STL file Water Jet propulsion unit, laurentfevrier79

Did you 3D print this model?

Water Jet propulsion unit

Maker
3D Model

Make's Description

Nouveau dans l'impression 3d, c'est long lol, 30 heures pour le corps, 13 pour la buse ( 0.15 mm ) et 8 pour l'helice ( 0,1 mm). Super rendu le carbon mais attention, ça use vraiment beaucoup la buse.

  • Resolution: 0.15 mm
  • Temperature: 260 °C
  • Support: Yes
  • Infill: 100 %
  • Speed: 70 mm/s

Add a comment

7 comments

Oh ok, I misunderstood. On your youtube video, is this configuration? Thank you for your answers

no, I am using SSS 56114 with 450KV

Your engine is Leopard 600kv? in 12S is not a can too fast? I think, low Kv and high voltage or higher kv with less voltage.

On your boat, what is your set up? You write 12S with esc flycolor 150 A. I have this esc but it is limited to 6S. I don't understand.

I don't no for the moment, probebly sss 56104 600kv. Or Turnigy t20 730 kv.

NICE! What motor are you going to use?